Hills FD12001 Use and Care Manual download pdf (Page 9)

Assembly and Line Tensioning

G. Fit the cover caps and trim the line as shown in steps 7 and 8.

Step 7

Feed end of the line through each cover cap and

ﬁt by rotating clockwise using the cover cap tool

provided until a slight ‘click’ is felt.

NOTE: A short video showing the attachment of

line segments is available for viewing on the Hills

website: www.hills.com.au

Step 8

Trim off any excess line ﬂush with end of each cover

cap as shown.

We recommend trimming excess line after a few

loads of washing have been hung to allow ‘pre-

stretch’ of line to occur.

Your Portable Clothesline is now ready to use.

Caution: Do not push or pull your Portable Clothesline across the floor as this could

lead to breakage of the legs. To move the clothesline, lift completely from the floor.

Line Tensioning

To re-tension lines if required

A. Remove either cover cap on the arm, by rotating anti-clockwise.

B. Untie the existing line.

C. Repeat steps F and G as described on pages 8 and 9.

DONOTOVERTENSION,asyoucandistorttheframe.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Hills FD12001 Use and Care Manual Page 9